7/2/2023 0 Comments Musik kompressor![]() ![]() As a standard, a high-quality power supply unit located in the compressor is attached to the turntable. To change the speed and to fine-adjust the disc’s rotation speed, use the control panel located on the back of the turntable. The turntable can play discs recorded at 33 and 45 RPM. The bearing is made with high precision to create an air film between the two elements. The entire uppermost platter levitates about 1mm in the air. The platter bearing levitates on the air cushion which reduces possible resonance to zero. The magnets at the same time keep the upper platter aloft over the sub platters and drag it according to the sub platters’ movement. The movement of this platter is transferred to the actual platter using small magnets. Two thin silicone belts transmit the torque from the motor, which is located next to the platter, to the bottom acrylic sub-platter. Due to the wide range of calibration options, the arm can support most MM /MC cartridges available on the market.Ī quiet DC motor (12V) and two sub-platters are used to drive the disc. The attachment of the arm guide on two sides reduces the resonance to zero. The precise execution of the arm components allows for the use of a very low air pressure which reduces the compressor’s noise to virtually zero. In this design, the pressure to the arm bearing is supplied through tiny holes in the guide. Thanks to the pressure from the compressor, the arm bearing can detach and levitate in the air alongside the guide. The way the arm is operated on the air cushion is quite simple. This pressure is efficiently produced by a very quiet compressor, which is an inseparable part of the turntable. The air pressure (0.040MPa) is needed for the turntable to work properly. Led lights under platter RGB ( If wanted) ![]() ![]() Platter nr1 diameter/height/weight 310 x 20 x 2kg ![]()
0 Comments
Leave a Reply. |